Aiwa DINA Z-A60 - Manual (Page 9)

ENGLISH
9
En
T
APE PLA
YBACK
RADIO RECEPTION
PRESETTING STATIONS
The unit can store a total of 32 preset stations for all bands.
When a station is stored, a preset number is assigned to the
station. Use the preset number to tune in to a preset station
directly.
1 Press TUNER/BAND to select a band, and tune in
to a station with f f f f f DOWN or g g g g g UP.
2 Press a a a a a SET to store the station.
A preset number beginning from 1 in consecutive order for
each band is assigned to a preset station.
3 Repeat steps 1 and 2.
No more stations will be stored if a total of 32 preset stations
for all the bands have already been stored.
NOTE
“FULL” is displayed if you attempt to store more than 32 preset
stations.
PRESET NUMBER TUNING
Use the remote control to select the preset number directly.
1 Press BAND while pressing SHIFT to select a
band.
2 Press numbered buttons 0-9 and +10 to select a
preset number.
Example:
To select preset number 20, press +10, +10 and 0.
To select preset number 15, press +10 and 5.
Selecting a preset number on the main unit
Press TUNER/BAND to select a band. Press TUNER PRESET
repeatedly until the preset number flashes (preset tuning mode),
and turn MULTI JOG. The preset numbers are selected in
sequence as you turn MULTI JOG.
•
c PRESET is also available to select the preset number. Each
time the button is pressed, the next highest number is selected.
To clear a preset station
Select the preset number of the station to be cleared with the
numbered buttons. Then, press
s CLEAR, and press a SET
within 4 seconds.
The preset numbers of all other stations in the band with higher
numbers are decreased by one.
Frequency Preset number
BASIC OPERATIONS
This unit is designed for optimal playback of Type I (normal) tapes.
1 Press TAPE/DECK 1/2, then press z PUSH EJECT
to open the cassette holder.
Insert a tape with the exposed side down. Push the cassette
holder to close.
2 Press c to start play.
Only the side facing out from the unit can be played back.
To select a playing deck
When tapes are loaded in both decks, press TAPE/DECK 1/2
first to select a deck.
The selected deck number is displayed.
To stop play, press s s s s s .
To pause play (Deck 2 only), press a a a a a . To resume play, press
again.
To fast forward or rewind, press
f f f f f or g g g g g .
Then press s s s s s to stop the tape.
To start play when the power is off (Direct Play Function)
Press TAPE/DECK 1/2. The power is turned on and play of the
inserted tape begins.
To set the tape counter to “0000”.
Press
s CLEAR in stop mode.
The counter is also set to “0000” when the cassette holder is
opened.
When tapes are loaded in both decks
After playback on deck 1 finishes, the tape in the deck 2 will start
to play without interruption and will stop at the end of the tape.
(Continuous play)
TAPE PLAYBACK
Playing deck number
The tape counter indicates
the tape running length.
DECK 2
f , g
a
s
1
2
z PUSH
EJECT
z PUSH
EJECT
DECK 1
MULTI
JOG
TUNER
PRESET
TUNER
BAND
0-9,
+10
SHIFT
BAND
f , g
c
s
a
f , g
s CLEAR
a SET
c PRESET