Spektrum SPMAR6400LBL - Manual (Page 5)

EN
5
Smart Bind ™
You must first bind the receiver to the transmitter for it to operate. Binding is teaching the receiver
the specific code of the transmitter so it only connects to that transmitter. The AR6400LBL features
Smart Bind. When the receiver is first powered, the receiver looks for the signal of its previously
bound transmitter for 5 seconds. If no signal is found, the receiver automatically goes into bind mode
indicated by the flashing LED.
Binding
1. Make sure the flight battery is fully charged.
2. Confirm the flight battery is disconnected from the receiver/ESC unit and the transmitter is turned off.
3. Plug the flight battery into the receiver’s battery connector. After 5 seconds the LED on the receiver
begins to flash.
4. After verifying the LED is flashing on the receiver, bind the receiver to the transmitter. (See your
transmitter’s manual or the supplement that follows.)
5. If you entered bind mode correctly, you will see a solid LED within about 10 seconds. You should
now be bound to the transmitter and have full control and function.
IMPORTANT: Once the system is bound, ALWAYS turn the transmitter on first and then the receiver
to prevent the receiver from re-entering bind mode. If your receiver inadvertently enters bind mode,
unplug the battery from the receiver and reinstall with the transmitter remaining on.
LED
Transmitter Specific Binding Instructions
1. To bind the AR6400LBL to the transmitter, plug the battery into the receiver. The LED on the
receiver will begin flashing.
2. Move the sticks and switches on the transmitter to the desired failsafe positions (low throttle and
neutral control positions).
3. DX5e: Pull and hold the Trainer Switch on the transmitter while turning the transmitter on.
Release the trainer switch once the LEDs on the front of the transmitter flash.
DX6i: Pull and hold the Trainer Switch on the transmitter while turning the transmitter on.
Release the trainer switch once the word BIND flashes on the LCD screen on the front of
the transmitter.
DX7, DX7se: Press the bind button on the back of the transmitter while turning the transmitter on.
The bind button on the back of the transmitter will flash.
Release the button after 2–3 seconds.
4. The LED on the receiver will go solid and the system will connect after several seconds.