Spektrum SPMAR6410LBL User Manual
Page 13
EN
13
Timing
• Pull throttle to center, hold for 5 seconds (2 long beeps).
5°: Push throttle to full (1 short beep).
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
10°: Keep throttle at full for 5 seconds (2 short beeps).
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
15°: Keep throttle at full for 10 seconds (3 short beeps). (Default)
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
20°: Keep throttle at full for 15 seconds (4 short beeps).
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
25°: Keep throttle at full for 20 seconds (5 short beeps).
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
Throttle
Range
• Pull throttle to center, hold for 10 seconds (3 long beeps).
1.2–1.8ms: Push throttle to full (1 short beep). (Default)
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound)
1.1–1.9ms: Keep throttle at full for 5 seconds (2 short beeps).
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
Starting
Rate
• Pull throttle to center, hold for 15 seconds (4 long beeps).
0.25s: Push throttle to full (1 short beep). (Default)
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
1.0s: Keep throttle at full for 5 seconds (2 short beeps).
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
PWM Switching
Frequency
• Pull throttle to center, hold for 20 seconds (5 long beeps).
8kHz: Push throttle to full (1 short beep). (Default)
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
16kHz: Keep throttle at full for 5 seconds (2 short beeps).
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
32kHz: Keep throttle at full for 10 seconds (3 short beeps).
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
Mode
• Pull throttle to center, hold for 25 seconds (6 long beeps).
Normal Mode: Push throttle to full (1 short beep). (Default)
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
Heli Mode: Keep throttle at full for 5 seconds (2 short beeps).
Pull back to center throttle to confirm setting (Hi Lo Hi Lo sound).
Important: Cutoff voltage: 6.1V cannot be changed.
Recycle ESC power with throttle idle after changing settings.
Recycle power after you hear the Hi Lo Hi Lo confirming beeps after
changing settings.