Spektrum SPMAR6410LBL User Manual

Page 11

Reversing Optional Linear Servo

Reversing the servo is useful when implementing certain installations, such as

dual ailerons, flaps, etc. Spektrum offers a servo reversing lead you can connect to

the receiver and optional servo.

To reverse the servo using a reversing lead:
1. Connect the reversing lead to the servo.
2. Plug the servo into the CH2 or Reversed CH2/CH6 ports.
3. Power the receiver using a charged battery.
4. Once the receiver connects, the servo is now reversed.
5. Disconnect the battery from the receiver.
6. Remove servo reversing lead and store it in a safe place for future use.
7. Reinstall the servo lead into the servo port.

To Change CH6 to a Reversed CH2 for Dual Ailerons or

Reversed CH2 to CH6

1. Ensure the receiver and transmitter are bound.

2. Turn the transmitter on.
3. Move the THRO stick to the full throttle position.
4. Move the control sticks to the corresponding position to change between the

available options (see illustration).

5. While holding this position, connect the battery to the receiver; power on the

receiver.

6. The LED on the receiver will turn solid and within 5 seconds, the LED will flash

3 times quickly, indicating the option is now changed.

7. Disconnect the flight pack from the receiver.
8. Turn the transmitter off.

Mode 1

Mode 2

Rev. CH2/CH6

1. Full THRO

2. Up ELEV

3. Left AILE

THRO/RUDD ELEV/AILE

ELEV/RUDD THRO/AILE