beautypg.com

Spektrum SPMAR7010 User Manual

Page 11

background image

11

EN

• Receiver battery pack (number of cells, capacity, cell type, state of charge)
• The ESC’s capability to deliver current to the receiver in electric aircraft
• The switch harness, battery leads, servo leads, regulators etc.
The AR7010 has a minimum operational voltage of 3.5 volts; it is highly recommended

the power system be tested per the guidelines below.
Recommended Power System Test Guidelines

If a questionable power system is being used (e.g., a small or old battery, an ESC that

may not have a BEC that will support high-current draw, etc.), perform the following

test with a voltmeter. The Hangar 9

®

Digital Servo & Rx Current Meter (HAN172) or the

Spektrum Flight Log (SPM9540) work well for this test.
Plug the voltmeter into an open channel port in the receiver and with the system on, load

the control surfaces (apply pressure with your hand) while monitoring the voltage at the

receiver. The voltage should remain above 4.8 volts even when all servos are heavily

loaded.

CAUTON: When charging Ni-MH batteries, make sure the battery fully charges.

Ni-MH batteries charged with peak detection fast charger have a tendency to

false peak (i.e. not fully charge), which could lead to a crash.

QuickConnect™ With Brownout Detection (DSM2 Only)
Your AR7010 features QuickConnect with Brownout Detection.
• Should an interruption of power occur (brownout), the system will reconnect

immediately when power is restored (QuickConnect).

• The LED on the receiver will flash slowly, indicating a power interruption

(brownout) has occurred.

• Brownouts can be caused by an inadequate power supply (weak battery or

regulator), a loose connector, a bad switch, an inadequate BEC when using an

Electronic speed controller, etc.

• Brownouts occur when the receiver voltage drops below 3.5 volts, thus interrup-

ting control as the servos and receiver require a minimum of 3.5 volts to operate.

How QuickConnect With Brownout Detection Works
• When the receiver voltage drops below 3.5 volts, the system drops out (ceases

to operate).

• When power is restored, the receiver immediately attempts to reconnect to the

last two frequencies it was connected to.

• If the two frequencies are present (the transmitter was left on), the system

reconnects typically in about 4/100 of a second.

QuickConnect with Brownout Detection is designed to allow you to fly safely through

most short duration power interruptions. However, you must correct the cause of these

interruptions before your next flight to prevent a crash.

CAUTION: If a brownout occurs in flight, determine the cause of the brownout

and correct it before attempting to fly again.

Flight Log (SPM9540 Optional)

The Flight Log is compatible with the AR7010. The Flight Log displays overall RF link

performance as well as the individual internal and external receiver link data.

Additionally, it displays receiver voltage.