Spektrum SPMAR7200BX - Manual (Page 9)

EN
9
Selection Within menu points
The Status LED color indicates menu point options. The options are:
Move the rudder stick left to move counterclockwise through the options. Move
the rudder stick right to move clockwise through the options. The available
options depend on the menu point.
Switching to the Next menu point
Quickly press the setup button to move to the next menu point. It is possible to
skip menu points by pressing the setup button. Do not move the transmitter sticks
when you are in a menu point you want to skip.
Exiting the menu
When LED (N) is solid, quickly press the setup button to exit the menu. The
AR7200BX will also automatically exit the menu after 4 minutes of inactivity. The
AR7200BX will not automatically exit at points D, G, I and J to allow time for
mechanical helicopter adjustments.
CAUTIoN: Never fly the helicopter when the AR7200BX is in the Setup or
Parameter Menu. Gyro control and transmitter stick controls are disabled when
the AR7200BX is in the Setup or Parameter Menu.
Factory Reset
To erase all AR7200BX settings:
In any setup menu (A through N), press and hold the setup button for at least 10
seconds until LEDs (A) – (N) and (J) quickly flash to confirm the reset.
Any previous programming is deleted during a reset.
CAUTIoN: Do not attempt to fly the helicopter without doing a complete
setup procedure after a reset. If you do not complete the setup, the helicopter
will crash, causing property damage and injury.
Unplug all servos and remove the servo horns before resetting the AR7200BX.
Status-LED
OFF
Purple Solid
Red Flashing
Red Solid
Blue Flashing
Blue Solid
LED solid: LED flashing:
Rudder Stick