Spektrum SPMAR7200BX - Manual (Page 10)

EN
10
Setup menu
The following section describes each menu point and the available settings.
A. mounting orientation
The AR7200BX can be mounted horizontally or vertically. The only restriction
is that the servo plug connectors MUST point toward the front or rear of the
helicopter.
Status-LED
Red Solid Vertical (on the side)
Blue Solid Horizontal (flat)*
Push the setup button to save the selection and move to menu point (B).
B. Swashplate Servo Frequency
CAUTIoN: If you do not know the maximum pulse rate for your servos,
do not exceed 50Hz servo frequency. A higher servo frequency can lead
to servo failure. Analog servos usually tolerate a maximum of 50Hz. Contact the
servo manufacturer if you are unsure of the servo frequency.
Always use the highest servo frequency that the servos will handle for the best
performance.
Status-LED
OFF User Defined (requires PC software)
Purple Solid 50Hz*
Red Flashing 65Hz
Red Solid 120Hz
Blue Flashing 165Hz
Blue Solid 200Hz
Push the setup button to save the selection and move to menu point (C).
To see a complete Spektrum servo reference chart, refer to the servo chart on
spektrumrc.com.
*=Factory
Setting
*=Factory
Setting