Spektrum SPM3100 DX3R - Manual (Page 10)

10 SPEKTRUM DX3R PROGRAMMING GUIDE
ChangIng To
lefT-handed ConfIguraTIon
The DX3R is shipped set up for right-handed use but
can easily be switched to left-handed configuration.
All the parts necessary to convert to left-handed,
including the grip plates, the back cover and the
front shell are included. A 3/32-inch hex wrench and
a small Phillips screwdriver will be needed.
1. Remove the batteries from the transmitter. This
prevents the possibility of accidentally causing a
short during the conversion.
2. Carefully remove the grip cover by prying
with your fingers at the forward edge of the
rubber grip.
3. Use a 3/32inch hex wrench remove the three
screws on the front of the steering housing
as shown.
4. Carefully remove the steering mechanism
and unplug the steering connector. Also
remove the backplate.
5. Using a small Phillips screwdriver, remove the
four Phillips screws (two per side) that fasten the
grip plates in place and remove the grip plate that
doesn’t have the buttons attached.