Allied Telesis AT-8324SX - Manual (Page 42)

Installing the Stack
42
Desktop or Shelf
Mounting
To rack mount devices, perform the following procedure:
1. Attach the four adhesive feet to the bottom of the first switch.
Figure 13 Attaching the Adhesive Feet
2. Set the device on a flat surface near an AC power source, making sure
there are at least 5 centimeters (2 inches) of space on all sides for
proper air flow.
3. If installing a single switch only, go to Connecting to a Power Source
on page 44.
4. If installing multiple switches, attach four adhesive feet to each one.
Place each device squarely on top of the one below, in any order.
5. If also installing RPUs, place them close to the stack.