Allied Telesis FastSwitch8 - Manual (Page 14)

Installation
8
Figure 4 Interlock Cap
To Interlock a Group of LanEdge Products on a Desktop
The interlocking feature of the LanEdge products makes it easy for you to
install the units on a desk or table. You can place the units on top of each other
and interlock them to form a stack. A stack can consist of any combination of
LanEdge hubs. It is recommended that the heaviest unit be placed as the base
(bottom) unit. For example, if you are installing a LanEdge FastPrint Server,
place it as the base unit; otherwise, if you are installing a LanEdge
OmniConnect; place it as the base unit.
1. Select the base unit and place it upside down on a work surface. Locate
the rubber feet and bumpers from the accessory bag. Remove the
paper cover from the adhesive and press a rubber foot into each round
receptacle on the bottom of the unit. Remove the paper cover from the
adhesive and press a rubber bumper into each square receptacle on
the bottom of the unit.
2. Place each of the other units upside down on a work surface. Locate
the rubber feet and bumpers from the accessory bag. Do not install
the square rubber bumpers. Remove the paper cover from the
adhesive and press a round rubber foot into each round receptacle on
the bottom of the unit.
Note
The LanEdge products will not interlock properly if the square rubber
bumpers are installed on the interlocking (upper) units; install these
bumpers only on the base unit.