Allied Telesis AT-FS708LE - Manual (Page 33)

AT-FS708LE Installation Guide
33
❑ Check to be sure that you are using the
correct type of cable: Category 3, 4, or 5 for
10 Mbps operation and Category 5 cable
for 100 Mbps operation.
❑ Verify that the cable has not been cut or
damaged.
3. If the LNK/ACT LED for a port is ON but
there is a communication problem to the end-
node connected to the port, such as the loss of
data, check the following:
❑ Check to be sure that the distance
between the switch and the connected
network device is no greater than 100
meters (328 feet).
❑ Verify that you are using the correct type
of cable: Category 3, 4, or 5 for 10 Mbps
operation and Category 5 cable for 100
Mbps operation.