Allied Telesis AT-FS708LE - Manual (Page 30)

30
4. Position the switch onto the wall screws with
the LEDs either facing up or down.
Warning
The power cord is used as a
disconnection device. To de-energize
equipment, disconnect the power cord.
5
5. Plug the power adapter into a power source
and then plug the DC power cord into the DC
connector on the front panel of the switch.
6. Make sure the PWR LED on the front panel
is green. If the LED is OFF, refer to
“Troubleshooting” on page 32.
7. Connect the twisted pair cables to the twisted
pair ports on the switch and on the end-
nodes.
8. Power ON the end-nodes connected to the
switch.
9. Check that the LNK/ACT LED for each port
on the switch is green. If a LED is OFF, refer
to “Troubleshooting” on page 32.
The AT-FS708LE switch is now ready for use.