Allied Telesis AT-S63 - Manual (Page 122)

Chapter 9: Event Logs and the Syslog Client
122 Section II: Advanced Operations
Modifying Syslog Output Definitions
To modify a syslog output definition:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the System button.
3. Select the Event Log tab, shown in Figure 30 on page 108.
4. In the Configure Log Outputs section of the tab, click the radio button
of the log output file you want to modify and click the Modify button to
display the Modify Event Log Output window. An example of the
window is shown in Figure 35.
Figure 35. Modify Event Log Output Window
5. Modify the parameters as needed. The parameters are described in
Table 18 on page 119.
6. Click the Apply button to apply your changes or the Close button to
close the window without making changes.
7. To save your changes in the master configuration file, click the Save
Config button in the Configuration menu.