Allied Telesis x600-48Ts/XP - Manual (Page 57)

x600 Layer 3 Gigabit Ethernet Switch Installation Guide
57
Installing the Power Cord Retaining Clip
Perform the following procedure to install the power cord retaining clip on
the switches:
1. Locate the power cord retaining clip, shown in Figure 21.
Figure 21. Power Cord Retaining Clip
2. Install the clip on the AC power connector on the rear panel of the
switch. With the “u” of the clip facing down, press the sides of the clip
toward the center and insert the short ends into the holes in the
retaining bracket, as shown in Figure 22.
Figure 22. Inserting the Retaining Clip into the Retaining Bracket
You are now ready to install the switches in the equipment rack, as
explained in the next procedure.
100-240V
AC ~
100-240V
AC ~