Allied Telesis x600-48Ts/XP - Manual (Page 18)

Chapter 1: Overview
18
Introduction
The x600 Series Switches are managed Gigabit Ethernet switches that act
as standalone units. There are four Basic Layer 3 switches in the series:
ˆ x600-24Ts Switch
ˆ x600-24Ts/XP Switch
ˆ x600-48Ts Switch
ˆ x600-48Ts/XP Switch
The x600-24Ts and the x600-24Ts/XP switches both have 24
10/100/1000Base-T ports. The x600-48Ts and the x600-48Ts/XP
switches both have 44 10/100/1000 Base-T ports.
All four switches have four SFP transceiver slots, a Secure Digital (SD)
card slot, a console port, and a redundant power supply connector. In
addition, the x600-24Ts/XP and the x600-48Ts/XP switches have two XFP
transceiver slots.
On the back of all the switches there is an AC power connector, an RPS
connector, and an expansion slot. You can connect the RPS connector to
the AT-RPS3204 Redundant Power Supply. The x600 switches are
shipped with a blank expansion slot with the exception of the The
x600-48Ts/XP switch which is shipped with an AT-LBM (Loop Back)
module installed in the expansion slot.
The AlliedWare Plus Operating System Software runs on all the x600
switches.
For more detailed information about the switches, including illustrations,
see “Switch Descriptions” on page 19.