Allied Telesis AT-IFS802SP/POE - Manual (Page 87)

83 AT-IFS802SP/POE(W)-80 User Manual
Trunk Commands Set
Allied Telesis Commands Level Description Example
aggregator priority
[1~65535]
G
Set port group system
priority
switch(config)#aggregator priority 22
aggregator activityport
[Group ID]
[Port Numbers]
G Set activity port switch(config)#aggregator activityport 2
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
G
Assign a trunk group with
LACP active.
[GroupID] :1~3
[Port-list]:Member port
list, This parameter could
be a port range(ex.1-4) or
a port list separate by a
comma(ex.2, 3, 6)
[Workport]: The amount of
work ports, this value could
not be less than zero or be
large than the amount of
member ports.
switch(config)#aggregator group 1 1-4
lacp workp 2
or
switch(config)#aggregator group 2 1,4,3
lacp workp 3
aggregator group
[GroupID] [Port-list]
nolacp
G
Assign a static trunk group.
[GroupID] :1~3
[Port-list]:Member port
list, This parameter could
be a port range(ex.1-4) or
a port list separate by a
comma(ex.2, 3, 6)
switch(config)#aggregator group 1 2-4
nolacp
or
switch(config)#aggregator group 1 3,1,2
nolacp
show aggregator P
Show the information of
trunk group
switch#show aggregator 1
or
switch#show aggregator 2
or
switch#show aggregator 3
no aggregator lacp
[GroupID]
G
Disable the LACP function
of trunk group
switch(config)#no aggreator lacp 1
no aggregator group
[GroupID]
G Remove a trunk group switch(config)#no aggreator group 2