Allied Telesis AT-GS950/16PS - Manual (Page 38)

Chapter 2: System Configuration
38
Note
See Chapter 20, “Simple Network Management Protocol SNMPv1
and v2c” on page 263 and Chapter 21, “Simple Network
Management Protocol SNMPv3” on page 273 to configure the
remaining SNMP parameters.
4. Click Apply located under the Web Server Status Enable/Disable
field.
5. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
User Interface
Timeout
To set the Web Idle Timeout, perform the following procedure:
1. From the main menu on the left side of the page, click the System
folder.
The System folder expands.
2. From the System folder, select User Interface.
The User Interface Page is displayed. See Figure 10 on page 37.
3. Refer to the bottom portion of the web page. Enter the Web Idle
Timeout parameter. The range is from 3 to 60 minutes.
4. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.