Allied Telesis AT-GS950/16PS - Manual (Page 37)

AT-GS950/16PS Switch Web Interface User’s Guide
37
User Interface Configuration
This procedure explains how to enable and disable the user interfaces on
the switch. With this procedure you can enable or disable the AT-GS950/
16PS SNMP Agent. For more information about SNMP, go to Chapter 20,
“Simple Network Management Protocol SNMPv1 and v2c” on page 263
and Chapter 21, “Simple Network Management Protocol SNMPv3” on
page 273.
Note
The Web Server Status is displayed as Enabled for your
information only. The Web Server cannot be disabled.
SNMP Interface
To enable or disable the AT-GS950/16PS SNMP interface, perform the
following procedure:
1. From the main menu on the left side of the page, click the System
folder.
The System folder expands.
2. From the System folder, select User Interface.
The User Interface Page is displayed. See Figure 10.
Figure 10. User Interface Page
3. Choose Enable or Disable from the pull down list for the SNMP Agent
parameter.
Enabled - When you enable this parameter, the SNMP agent is
active. You can manage the AT-GS950/16PS switch with Network
Management Software and the switch’s private MIB.
Disabled - When you enable this parameter, the SNMP agent is
inactive.