Allied Telesis AT-GS950/16PS - Manual (Page 112)

Chapter 7: LACP Port Trunks
112
Port Priority Configuration
To select a priority for an LACP port, perform the following procedure:
1. Select the Bridge folder.
The Bridge folder expands.
2. From the Bridge folder, select the Trunk Config folder.
The Trunk Config folder expands.
3. From the Trunk Config folder, select Port Priority.
The AT-GS950/16PS Port Priority Page is displayed. See Figure 35
for a partial view of this page.
Figure 35. AT-GS950/16PS Port Priority Page
The System Priority is a preassigned value that you cannot alter. This
value applies to the switch. See “System Priority” on page 105.
The System ID is a MAC address value assigned to the switch. You
cannot change this value.
4. To set the port priority, select a value from 0 to 255 in the Priority
column for the port you want to alter. For more information, see “Port
Priority Value” on page 106
5. Select Apply.
6. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.