Allied Telesis AT-IMC1000TP/SFP - Manual (Page 17)

Cabling Installation Installing Copper Ethernet Cable
17 AT-IMC1000TP/SFP Industrial Gigabit PoE+ Media Converter
4. Cabling Installation
This section describes the cable installation for the AT-IMC1000TP/SFP.
4.1 Installing Copper Ethernet Cable
Insert a Category 5e cable into copper RJ-45 port (P1) and the other end of the cable into the network link-part-
ner’s copper RJ-45 port, ex: switch, PC, or Server. The cable between the link partner (switch, hub, workstation,
etc.) and the converter must be less than 100 meters (328 ft.) long and comply with the IEEE 802.3ab
1000Base-T standard for Category 5e or above.
When the AT-IMC1000TP/SFP is powered on and the link partner network device is active, the copper RJ-45
port (P1) LED will light up indicating a link or link activity. Please refer to the
LED Indicators section for LED light
meaning.
4.2 Installing SFP Module and Fiber Cable
Insert the proper SFP module and connect fiber cabling as explained in steps 7 and 8 of paragraph 5.2.1 . The
SFP port (P2) LED on the unit will light up when the AT-IMC1000TP/SFP is powered on and the link partner net-
work device is active,. Please refer to the
LED Indicators section for LED light meaning.