Allied Telesis AT-IMC1000TP/SFP - Manual (Page 16)

Mounting Installation Wall-Mount Plate Fixing
16 AT-IMC1000TP/SFP Industrial Gigabit PoE+ Media Converter
3.2 Wall-Mount Plate Fixing
Follow the steps below to mount the industrial switch with the wall mount plates included.
Note: Use # 1 Phillips screwdriver head.
1. Remove the DIN-Rail clip from the industrial switch by unscrewing the three DIN-Rail clip mounting screws.
2. Remove the four end plate chassis screws next to the rear panel of the chassis.
3. Position the wall-mount plates on the rear panel of the industrial switch.
4. Use the screws provided to secure the wall-mount plates on the industrial switch.
5. Use the hook holes at the corners of the wall-mount plates to hang the industrial switch on the wall.
6. To remove the wall-mount plates, reverse the steps above.
FIGURE 3-4 Attaching Wall Mount Plates