AFX CZPC425KBSCTD-WHWH - Manual

CZPC Series
Cable Mounted Pendants
Page 1 of 3 8060684 R0
FIG 3
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
Make sure that the power source conforms to the requirements of the
fixture. (See labels on fixture housing).
Models ending in MV, can be supplied with 120-277VAC. These
units are NOT DIMMABLE.
Models ending in SCTD, must be powered with 120VAC ONLY.
The units can be used with an approved dimmer. (Call American
Fluorescent Customer Service for dimming information) When
dimming: Only Use CFSB20K27D from American Fluorescent.
6 lamps MAXIMUM per dimmer switch.
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel.
This fixture is intended for use as general lighting in dry or damp
locations.
Assembly Instructions
1.
Preparing for installation.
A.
Disconnect electrical power before installing or servicing any part of this fixture.
B.
Unpack and lay out all fixture components to verify everything is included to fully assemble the
fixture.
C.
Please affix all aircraft cables with supplied connector adapters to prevent cables from coming
undone when assembled.
2.
Fixture assembly - Lighting fixture is partially assembled
A.
Lamp Shade / 11” Pan with Cord / Cable Assembly:
Remove the hex nut and lock washer from the 11” pan cable
assembly (do not remove the 1-1/8” flat washer).
Now, feed the cord through the center hole of the shade
assembly and mechanically secure it with the hex nut and
lock washer that you removed before.
Feed through the three aircraft cables (11) to the connectors
(14) that are mounted on the 11” pan. Insert the cable by
pressing the “Spring Pin” (12) Fig 5 downward and holding
until it comes out at the other end. Repeat these steps for the
other cables.
Note: Cable length adjustments might be needed again for
the correct cord length alignment.
B.
Take the fixture power cord wires (Fig 3) and slide them through
the canopy (6) strain relief assembly (8).
Cord Length Adjustments / Cutting / Stripping Wire Ends:
Before cutting the cord, measure the desired cord length for
pendant mounting. Tighten the strain relief by threading
tapered metal finial to mechanically secure the cord.
For wiring NEC (National Electrical Code) requirements,
cut the cord about 7” from the canopy (6) as shown in Fig 3.
Cut the cord outside jacket insulation about 3” from canopy (6) and then stripped 3/8” the
ends of the three wires (13) same as shown in Fig 3.
FIG 2
FIG 1