AFX MRF161200L30D1SN - Manual

Monroe Series
Surface Mounted LED Fixture
Models: MRF162100 / MRF162500
Page 1 of 1 8060818 R0
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that all wiring be performed by a qualified
electrician. This fixture must be wired in accordance with all national
and local electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
Make sure that the power source conforms to the requirements of the
fixture (see labels on fixture housing).
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel.
This fixture is intended to be used for general indoor lighting in dry
or damp locations only.
Assembly Instructions
1. Preparing for installation
A. Disconnect electrical power before installing or servicing
any part of this fixture
B. Remove fixture from carton; remove ceiling pan, diffuser,
and hardware kit
C. Thread two screws (1 – provided) into the junction box (not
provided). Leave about ½” of length exposed
2. Wiring
All wiring must take place inside junction box.
Caution : Make sure power is off at fuse or circuit breaker box.
Check power wires for damage or scrapes. If power supply
wires are within three inches of LED drier, use wire suitable for
at least 90C (194F). Note: Most dwellings built before 1985
have supply wire rated to 60C. Consult a qualified electrician
before installing.
A. This unit will not operate properly unless connected to a
“grounded” electrical circuit. Electrical shock, over heating,
low or no light output, and shortened lamp life can result if
proper grounding is not done. Securely attach green (or
green and yellow) wire to ground supply wire
B. Using wire nuts (provided), connect white (common) supply
wire to white fixture lead. Connect black (hot) supply wire
to black fixture lead. Do not mix wires. Pull on each wire
lead to make sure connections are secure. Make certain no bare wires are exposed outside of wire connectors. Note: fixtures
with universal voltage power supplies are pre-wired with a disconnect. Refer to the included guide for using the disconnect
C. Tuck all connections neatly into junction box
3. Mounting
A. Attach ceiling pan to junction box using keyhole slots and the two #8 –32 x 1” screws
B. Secure with stem assembly (3) and thumbnut (4)
4. Mounting diffuser
A. Install threaded washer (5) onto stem
B. Install diffuser (6) onto threaded stem, and set the washer to the appropriate height
C. Secure diffuser with square washer (7) and finial (8)
5. Power to the fixture can now be restored
Limited Factory Warranty
AFX Inc. hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions
for a period of 5 years from date of shipment from factory. This warranty covers all component parts and extends only to replacement of defective fixture
or components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.