AFX RHF12213QEN-LW - Manual

RHF Series
Flush Mount Ceiling Fixture
Page 1 of 1 8060387 Rev.0
Safety Precautions
Read all safety precautions and installation instructions carefully before
installing or servicing this fixture. Failure to comply with these instructions
could result in potentially fatal electric shock and/or property damage.
It is recommended that all wiring be performed by a qualified electrician. This
fixture must be wired in accordance with all national and local electrical
codes.
Do not handle any energized fixture or attempt to energize any fixture with
wet hands or while standing on a wet or damp surface or in water.
Make sure that the power source conforms to the requirements of the fixture
(see labels on fixture housing).
To reduce the risk of electrical shock, and to assure proper operation, this
fixture must be adequately grounded. To accomplish proper grounding, there
must be a separate ground wire (green) or bare metal contact (metal conduit)
between this fixture and the ground connection of your main power supply
panel. The green ground screw location is clearly marked on the fixture
housing.
This fixture is intended to be used for general indoor lighting in dry or damp
locations only.
Assembly Instructions
1.
Preparing for installation
A. Disconnect electrical power before installing or servicing any part of this fixture.
B. Remove fixture and hardware bag from carton.
2. Wiring
All wiring must take place inside junction box. Caution: Make sure power is off at fuse or
circuit breaker box. Check power wires for damage or scrapes. If power supply wires are within
three inches of ballast use wire suitable for at least 90C (194F). Note: Most dwellings built before
1985 have supply wire rated to 60C. Consult a qualified electrician before installing.
A. This unit will not operate properly unless connected to a “grounded” electrical circuit.
Electrical shock, overheating, low or no light output, and shortened lamp life can result if
proper grounding is not done. Securely attach green (or green and yellow) wire to ground
supply wire.
B. Using wire connectors (provided), connect white supply wire to white fixture lead. Connect
black hot supply wire to black fixture lead. Do not mix wires. Pull on each wire lead to make
sure connections are secure. Make certain no bare wires are exposed outside of wire connectors. Note: fixtures with
universal voltage power supplies are pre-wired with a disconnect. Refer to the included guide for using the disconnect.
3. Mounting
A. Mount Ceiling Pan (1) to junction box with the two #8-32 x 7/8” screws (2 - provided) through keyhole slots.
4. Lamps
A. Compact – 4-pin (Not shown or provided) insert lamp pins into lamp holder and press until lamp snaps in place.
B. GU24 – (3) insert lamp pins into lamp holder and rotate until lamp snaps in place.
C. Circline – (Not shown) insert lamp pins into lamp holder and press until lamp snaps in place.
5. Diffuser mounting
A. Insert inner diffuser (6) into diffuser (5)
B. The Shade diffuser (5) has three notches on its upper flange. (see figure 2) Align these notches with the standoffs (4) on
the outside ceiling pan (1) and push the diffuser up against the fixture housing.
C. Rotate the diffuser slightly (5) clockwise or counterclockwise until the standoffs rest within each diffuser slot.
D. Twist slightly to ensure proper engagement (see figure 3)
6. Power to the fixture can now be restored
Limited Factory Warranty
AFX Inc. hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions for a period of
2 years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or components; it does not cover failure
due to improper installation, misuse, mishandling or damage incurred in transit.
GU24
LAMPING SHOWN
FIG. 1
FIG. 2
FIG. 3