AFX CAC12218QMVSN - Manual

Carlisle Series Close-to-Ceiling Fixture
Models: CAC12/14/24
8060361 r0
www.afxlighting.com
1 of 1
Limited Factory Warranty
AFX Lighting, Inc. warrants this fixture is free from defects in materials and workmanship when installed and used under normal operating conditions
for a period of 3 years from date of purchase. This warranty covers all component parts and extends only to replacement of defective fixture or
components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.
Safety Precautions
Read all safety precautions and installation instructions carefully before
installing or servicing this fixture. Failure to comply with these
instructions could result in potentially fatal electric shock and/or
property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any fixture
with wet hands or while standing on a wet or damp surface or in water.
Make sure that the power source conforms to the requirements of the
fixture (see labels on fixture housing).
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) contact
between this fixture and the ground connection of your main power
supply panel.
This fixture is intended to be used for general indoor lighting in damp
locations.
ASSEMBLY INSTRUCTIONS
1. Preparing for installation
A. Disconnect electrical power at fuse or circuit breaker
box before installing or servicing any part of this
fixture.
B. Carefully remove the fixture from the carton, and check
that all parts are included, as shown in the figure.
C. If required, disassemble diffuser (8) and install lamps
(7). For CFQ lamps: push lamp into lamp holder until
it snaps in place. For GU24 lamps: insert lamp into
lamp holder and turn it clockwise until it snaps in place.
D. Reinstall diffuser (8) over pan (6). Install trim ring (9)
and brackets (11) using thumb nuts (10).
2. Wiring – all wiring must take place inside junction
box
Caution: Make sure power is off at fuse or circuit breaker
box. Check power wires for damage or scrapes. If
power supply wires are within three inches of the
ballast power supply, use wire suitable for at least 90C
(194F). Note: Most dwellings built before 1985 have
supply wire rated to 60C. Consult a qualified electrician
before installing.
A. Connect the power source ground wire to the green or
bare copper wire from the fixture assembly.
B. Using wire nuts, connect white supply wire to white fixture lead. Connect black supply wire to black fixture lead.
Do not mix wires. Pull on each wire lead to make sure connections are secure. Make certain no bare wires are
exposed outside of wire connectors. Note: fixtures with universal voltage power supplies are pre-wired with a
disconnect. Refer to the included guide for using the disconnect.
C. Tuck all connections neatly into junction box.
3. Mounting
A. Install gem bar (2) to junction box using the #8 machine screws (1 – provided). Note: fixture mounting screws
(3) are to be inserted in gem bar prior to installing gem bar.
B. Install fixture by securing the canopy (4) to the gem bar using thumbnuts (5).
4. Restore power at fuse or circuit breaker box
Model CAC14218QMVSN Shown