AFX ADLF432SNR8 - Manual (Page 4)

6 3
SAFETY INFORMATION
WARNING
• For installation in dry or damp residential applications.
• Read all safety precautions and installation instructions carefully before installing
or servicing this fixture. Failure to comply with these instructions could result in
potentially fatal electricshock and/or property damage.
• It is recommended that a qualified electrician perform all wiring. This fixture must
be wired in accordance with all national and local electrical codes. To reduce the
risk of electrical shock, and to assure proper operation, this fixture must be
adequately grounded.
CAUTION
• Instant-on 120 volt, 60Hz electronic ballast with minimum 0°F start.
• Do not handle any energized fixture or attempt to energize any fixture with wet
hands or while standing on a wet or damp surface or in water.
• Disconnect electrical power before installing or servicing any part of this fixture.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt
to assemble the product. Contact customer service for replacement parts.
Estimated Assembly Time: 45 minutes
Tools Required for Assembly (not included): (2) Mounting screws or toggle bolts,
(2) wire nuts, electrical tape, eye protection, Phillips screwdriver, ladder, wire cutter,
pliers, wire stripper, stud finder, drill with 1/4 in. bit.
If lamp is marked Hg it contains Mercury. Follow disposal laws. See www.epa.gov/bulbrecycling
ASSEMBLY INSTRUCTIONS
1. Disconnect electrical power before installing
fixture. To prevent light leaks between fixture
and ceiling, attach supplied gasked (D) to frame
(B), adhesive side facing frame. Follow the special
instructions found in the bag containing the gasket
material. (See Figure 1).
2. Locate holes on end plates of fixture body (A)
and remove the 3/8” knockouts. Place fixture
body (A) into frame (B) and locate the pre-drilled
holes on the inside of the frame. Use screws (AA)
to attach the fixture body (A) to the frame (B).
(See Figure 2). NOTE: Do not over-tighten
the screws.
D
Figure 1
B
Hardware Used
AA x 4 Screw
Figure 2
B
A
AA
CARE AND MAINTENANCE
• Periodically, dust the diffuser (inside and out) with a clean dry cloth. Wipe clean with a
slightly damp cloth as needed. Never use abrasive cleansers.
• Bulb Replacement: Use (4) 32-watt linear bulbs.
TROUBLESHOOTING
Problem Possible Cause Corrective Action
1. Fixture wiring problem 1. Check wiring for loose connections
2. No power or failed switch 2. Check power and switch
3. Worn-out lamp(s) 3. Replace lamp(s) as needed
4. Failed ballast 4. Replace ballast as needed
1. Fixture not properly grounded 1. Check grounding system
2. Wrong lamp(s) 2. Verify lamp is listed on ballast
3. One or more failing lamps 3. Replace lamps as needed
4. Failing ballast 4. Replace ballast as needed
Light fails to illuminate
Light flickers blinks or
lights ends only