Samsung RF34H9960S4-AA - Manual (Page 40)

English - 40
After dispensing Sparkling water, lift the Sparkling-
selector lever up.
Do not hang on the Sparkling-selector lever
and do not use excessive force to pull it
down or lift it up.
Water Dripping
Some time after you have dispensed sparkling water, a few drops of sparkling water can escape from the
dispenser. The water dripping is not a product defect, but a natural result of mixing CO
2
and water.
Controlling the Carbonation Level
You can change the sparkling water’s carbonation level by pressing the Sparkling Level button. Each time
you press the Spakling Level button, the carbonation level changes as follows:
Medium (Level-2) → Strong (Level-3) → Weak (Level-1) → Medium (Level-2). As you press the button, the
small numbers on the right side of the button light up in succession, indicating the level change.
The change in carbonation level is applied the next time the refrigerator makes sparkling water.
- If there is previously produced sparkling water inside the Sparkling Water tank, the refrigerator
dispenses sparkling water with the previous carbonation level. (Again, changes in the carbonation
level do not take affect until the next time the refrigerator makes sparkling water. The change does not
affect sparkling water that is already made.)
- While the refrigerator is producing sparkling water, the Sparkling Level icons light up in rotation
(Level-1 → Level-2 → Level-3 → Level-1, etc.). If you press the Sparkling Water button again while the
carbonation level is being displayed, the carbonation level changes. The change in the carbonation
level will take affect the next time the refrigerator makes sparkling water.
- The main number on the left side indicates the sparkling level of the current sparkling water, while the
small numbers on the right side indicate the sparkling level for the next process. Even if you change
the sparkling level while the refrigerator is producing sparkling water, the change is not applied to the
current process but is applied to the next process.
The Sparkling Level is set to Level 2 at the factory. If the sparkling water tastes too strong or too weak,
change the carbonation level. Level 1 provides a milder carbonation, Level 3 a stronger carbonation.
• If there is a power interruption when the refrigerator is making sparkling water, the refrigerator may re-
start the carbonation process when power returns and put too much carbonation into the water. If this
occurs, we recommend throwing out the overly carbonated water and starting the process again.
• The lifetime of the CO
2
cylinder can vary, depending on the Sparkling Levels you choose.
CAUTION
DA68-03013A-05.indb 40 DA68-03013A-05.indb 40 2014. 5. 28. 10:08 2014. 5. 28. 10:08