Samsung RF34H9960S4-AA - Manual (Page 12)

English - 12
When moving your refrigerator
To prevent fl oor damage, be sure the front leveling
legs are in the up position (above the fl oor).
Refer to “HOW TO LEVEL THE REFRIGERATOR”
in the manual on page 16.
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the same
height as the rest of the fl oor.
This surface should be strong enough to support a
fully loaded refrigerator.
To protect the fi nish of the fl ooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working.
When moving the refrigerator, you need to pull and
push it straight forwards or back. Do not wiggle it
from side to side.
REMOVING THE REFRIGERATOR
DOORS
If the refrigerator is too large to pass through your
doorways easily, you can remove the refrigerator
doors.
If you need to remove the doors. continue below. If
you do not need to remove the refrigerator doors,
go to `Leveling the Refrigerator' on page 16.
Tools you will need (Not provided)
Philips screwdriver
(+)
Flat-blade
screwdriver (-)
Socket wrench
3/8'' (10 mm)
Pliers
Allen wrench
5/32" (4 mm)
Allen wrench
7/32'' (5 mm)
Disconnect power to the refrigerator before
removing the doors or drawers.
• Be careful not to drop, damage or
scratch the doors/drawers while
removing them.
• Use care when you remove the doors/drawers.
The doors are heavy and you could injure
yourself.
• Re-attach the doors/drawers properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
WARNING
DA68-03013A-05.indb 12 DA68-03013A-05.indb 12 2014. 5. 28. 10:08 2014. 5. 28. 10:08