Samsung NP270E5J-K01US - Manual (Page 70)

68 69
Chapter 3.
Using the computer
Installing the TPM program
You can install the TPM program as follows. Install the program
according to the procedures below.
This program is only provided for models with Recovery and
the TPM function.
Method 1
1
Run Recovery and click on System Software.
- If your computer does not boot up or if System Software
does not display in the Recovery program, use Method 2
to install the TPM program.
2
Click on System Software Installation.
3
The SW Update program will be launched.
Select TPM Host SW and click Install Now.
If the system software media is supplied with the product,
you can install the program by using the system software
media (only when supplied.)
4
After the installation, if you click OK, the computer restarts.
Method 2
1
Turn the computer on and immediately press the F4 key
several times.
2
After a moment, the Recovery program runs.
Click System Software.
3
When a pop-up window appears to ask you to reboot the
system, click Yes.
The system starts to reboot. After a moment, the SW Update
program automatically runs.
4
Connect to the network.
5
Select TPM Host SW and click Install.
6
After the program is completely installed, click Close.
7
Close the SW Update window and reboot your computer
again.
Using the TPM Security Device
(Optional)