Samsung SC-D382-XAA - Manual (Page 70)

62_ English
playing back a tape on the lcd Screen
The playback function and speaker works only in Player mode. ➥ page 18
You can monitor the playback picture on the LCD screen.
1. Insert the tape you wish to view. ➥ page 34
2. Set the Select switch to TAPE. (SC-D383/D385 only)
3. Press the MODE button to set Player ( ).
4. Open the LCD screen.
Adjust the angle of the LCD screen and set the brightness or color if necessary.
➥ page 31
5. Press the Joystick, then move the Joystick (/) left or right to rewind or forward
the tape to the starting point.
To stop rewinding or forwarding, move the Joystick down ().
The camcorder stops automatically after rewinding or forwarding is completed.
6. Press the Joystick to start playback.
You can view the picture you recorded on the LCD screen.
To stop the play operation, move the Joystick down ().
adjusting the lcd bright / lcd color during playback
You can adjust the LCD bright/LCD color during playback.
The adjustment method is the same procedure as used in Camera mode. ➥ page 31
adjusting the Volume
When you use the LCD screen for playback, you can hear recorded sound from the
built-in speaker.
- Take the following steps to lower the volume or mute the sound while playing a
tape on the camcorder.
When sound is heard once the tape is in play, use the Zoom(VOL) lever to adjust the
volume.
- A volume level display will appear on the LCD screen.
- Levels may be adjusted from anywhere between "00" to "19".
- If you close the LCD screen while playing, you will not hear sound from the speaker.
When the Audio/Video cable is connected to the camcorder, you cannot hear sound
from the built-In speaker and cannot adjust the volume.
•
•
•
•
•
•
•
•
•
•
•
•
playback
AV DV
BATT.
MENU
W
T
MODE
POWER
CHG
MOV_0001 12:00 1.JAN.2008
0:00:30:23
60min
SP
[11]
STOP
MIX[1+2]
16BIt S
AV In
12:00 1.JAN.2008
0:00:30:23
60min
SP
BATT.
CHG
MODE TAPE CARD
(SC-D383/D385 only)