Samsung ML-1450-XAX - Manual (Page 27)

2.8 S
ETTING
U
P
Y
OUR
P
RINTER
1
Make sure that both the printer and
the computer are turned off.
2
Plug the parallel printer cable into the
connector on the back of the printer.
Push the metal clips down to fit inside
the notches on the cable plug.
3
Connect the other end of the cable to
the parallel interface port on your
computer, and tighten the screws.
See your computer documentation if
you need help.
Connect to the Computer
with a Parallel Cable
➞ To the parallel
port on PC
If you are using a USB interface
Go to page 2.17 , “Installing USB Driver.”
Note: USB cable shorter than 3m is recommended.
If you are using a network interface
Go to page F.5 , “Network Interface Card.”
Notes:
• ML-1451N comes with a built-in network interface.
• Shielded cables must be used with this equipment
to maintain compliance with the EMC Directive (89/336/EEC).
Note: To connect the printer to the parallel port of the computer requires a certified parallel cable.
You will need to buy the IEEE1284 compliant cable.