5 primary ide master/slave, Primary ide master/slave -21, Pio mode [auto – Asus E3746 User Manual
Page 99: Udma mode [auto, Primary ide master/slave [auto
ROG Striker II Extreme / Striker II NSE
4-21
4.4.5
Primary IDE Master/Slave
While entering Setup, the BIOS automatically detects the presence of IDE devices.
There is a separate sub-menu for each IDE device. Select a device item then
press
The BIOS automatically detects the values opposite the dimmed items
(Capacity, Cylinder, Head, Sector and Transfer Mode). These values are not
user-configurable. These items show N/A if no IDE device is installed in the
system.
PIO Mode [Auto]
Sets the PIO mode for the IDE device.
Configuration options: [Auto] [Mode 0] [Mode 1] [Mode 2] [Mode 3] [Mode 4]
UDMA Mode [Auto]
Disables or sets the UDMA mode. Configuration options: [Disable] [Auto]
Primary IDE Master/Slave [Auto]
Select [Auto] to automatically detect an IDE hard disk drive. If automatic detection
is successful, the BIOS automatically fills in the correct values for the remaining
fields on this sub-menu. If the hard disk was already formatted on a previous
system, the setup BIOS may detect incorrect parameters. Select [Manual] to
manually enter the IDE hard disk drive parameters. If no drive is installed select
[None]. Configuration options: [None] [Auto] [Manual]
Select Menu
Item Specific Help
Set a PIO mode for the
IDE device. Mode0
through 4 successive
increase in
performance.
F1:Help ↑↓ : Select Item
-/+: Change Value
F5: Setup Defaults
ESC: Exit →←: Select Menu
Enter: Select SubMenu F10: Save and Exit
Primary IDE Master
PIO Mode
[Auto]
UDMA Mode
[Auto]
Primary IDE Master
[Auto]
Access Mode
[Auto]
Capacity
0 MB
Cylinder
0
Head
0
Sector
0
Transfer Mode
None
Phoenix-AwardBIOS CMOS Setup Utility
Main