6 sata 1–6, Sata 1–6 -23, Extended ide drive [auto – Asus E3746 User Manual
Page 101: Access mode [auto, Capacity, Cylinder, Head, Landing zone
ROG Striker II Extreme / Striker II NSE
4-23
4.4.6
SATA 1–6
While entering Setup, the BIOS automatically detects the presence of Serial ATA
devices. There is a separate sub-menu for each SATA device. Select a device item
then press
The BIOS automatically detects the values opposite the dimmed items
(Capacity, Cylinder, Head, Landing Zone and Sector). These values are not user-
configurable. These items show 0 if no SATA device is installed in the system.
Extended IDE Drive [Auto]
Selects the type of fixed disk connected to the system.
Configuration options: [None] [Auto]
Access Mode [Auto]
Sets the sector addressing mode. Configuration options: [��arge] [Auto]
Before attempting to configure a hard disk drive, make sure you have the
correct configuration information supplied by the drive manufacturer. Incorrect
settings may cause the system to fail to recognize the installed hard disk.
Capacity
Displays the auto-detected hard disk capacity. This item is not configurable.
Cylinder
Shows the number of the hard disk cylinders. This item is not configurable.
Head
Shows the number of the hard disk read/write heads. This item is not configurable.
Landing Zone
Shows the number of landing zone per track. This item is not configurable.
Select Menu
Item Specific Help
Selects the type of
fixed disk connected to
the system.
F1:Help ↑↓ : Select Item
-/+: Change Value
F5: Setup Defaults
ESC: Exit →←: Select Menu
Enter: Select SubMenu F10: Save and Exit
SATA 1
Extended IDE Drive
[Auto]
Access Mode
[Auto]
Capacity
0 MB
Cylinder
0
Head
0
Landing Zone
0
Sector
0
Phoenix-AwardBIOS CMOS Setup Utility
Main