4 jmicron® raid configuration, Jmicron, Raid configuration -43 – Asus E3746 User Manual
Page 169: 4 jmicron, Raid configuration, Before creating a raid set, The jmicron, Windows, Os had been installed
ROG Striker II Extreme / Striker II NSE
5-43
5.4.4
JMicron
®
RAID Configuration
The JMicron
®
Serial ATA controller allows you to configure RAID 0, RAID 1 and
JBOD sets on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1. Two SATA HDDs, preferably with the same model and capacity.
2. A write-enabled floppy disk (Windows XP). A write-enabled floppy disk or a
USB flash disk drive (Windows �ista)
3. Microsoft
®
Windows
®
OS installation disk (Windows XP/Windows Vista)
4. Motherboard support DVD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install two external Serial ATA hard disk drives on your system.
2. Set the JMicron RAID controller item in the BIOS to [RAID]. See section
4.5.3 Onboard Device Configuration for details.
3. Enter the �MB363 RAID BIOS utility to set up your RAID configuration.
4. Create a JMB363 RAID driver disk for Windows
®
OS installation. See section
5.5 Creating a RAID driver disk for details.
5. Install the JMB363 driver after the Windows
®
OS had been installed.
Always install the JMB363 driver before creating RAID sets.
Select Menu
Item Specific Help
Press [Enter] to
setHD Audio function.
Phoenix-AwardBIOS CMOS Setup Utility
Advanced
F1:Help ↑↓ : Select Item
-/+: Change Value
F5: Setup Defaults
ESC: Exit →←: Select Menu
Enter: Select SubMenu F10: Save and Exit
Onboard Device Configuration
HD Audio
[Auto]
Front Panel Support Type [HD Audio]
Onboard 1st nVidia LAN [Enabled]
Onboard 2nd nVidia LAN [Enabled]
JMicron RAID controller [IDE]
Onboard LAN Boot ROM
[Disabled]
Onboard 1394
[Enabled]