Campbell Scientific Sentek EnviroSCAN Access Tube Installation Guide - Manual (Page 55)

Toolkit items
© Sent ek Pt y Lt d Page 52
Part No. 70030 Heavy Duty T-Handle The Heavy Duty T-Handle is a
reinforced T-Handle that attaches to
the auger extensions, that is
designed to withstand light blows
from a sledge hammer.
Part No. 70190 Tommy bars The tommy bars are used to tighten
and loosen installation tools to and
from extension rods. They are also
used to combine or detach multiple
extension rods.
Part No. 80090 Slurry Powder (5 kg bag of
kaolin clay) The kaolin clay is mixed together
with grey cement and water to form
the slurry mixture used in slurry
installations.
Part No. 81035 Access Tube Installation
Manual
Optional Tools for Access Tube Installation
Part No. 70015 Auger Extension 1.0 m
reinforced The reinforced extension rods are
used with the Heavy Duty T-Handle
and the Rock Breaker Tool.
Part No. 70025 Rock breaker 54.0 mm The 54.0 mm Rock Breaker is
attached to the special reinforced
extension rods and the Heavy Duty
T-Handle and it is used to hammer
and break rocky obstacles when
drilling an oversized hole for the
slurry method.
Part No. 70027 Rock breaker 47.0 mm The 47.0 mm Rock Breaker is
attached to the special reinforced
extension rods and the Heavy Duty
T-Handle and it is used to hammer
and break occasional rocky
obstacles when installing using the
“through the tube installation”
method.
Part No. 70030 Heavy Duty T-Handle The Heavy Duty T-handle is the
hammer base for the Rock Breaker
tools. It can also be used in heavy
clay soils where augering becomes
difficult.
Part No. 70035 Open centre tungsten tip
auger 47.0 mm The 47.0 mm Open Centre Tungsten
Tip Auger is designed to be used in
gravel and stone soils (where the
47.0 mm regular auger fails), using
the Standard manual installation
method.
Part No. 70045 Open centre tungsten tip
auger 61.0 mm The 61.0 mm open centre tungsten
tip auger is designed to be used in
severe gravel and stone soils where
the regular 61.0 mm slurry auger
fails.