Campbell Scientific Sentek EnviroSCAN Access Tube Installation Guide User Manual

Page 54

Toolkit items

Page 51

Part No. 70215

3 x Tripod anchor pins

The 600 mm tripod anchor pins are
used to fix the tripod in place during
the installation.

Part No. 70220

1 x Tripod base plate

The base plate is attached to the
base of the tripod and prevents the
tripod from compacting the soil
around the top of the access tube.

Part No. 70225

1 x Auger centralization
poly guide

The auger centralization poly guide
is used to centre the auger extension
rod within the tripod during pre-
drilling. Note: The auger
centralization poly guide is only used
for installations that do not used the
“through access tube installation”
method.

Part No. 70230

1 x Access tube installation
tripod

The access tube installation tripod is
used to stabilize the access tube
during the installation process. The
tripod prevents the access tube from
flexing. Flexing allows air to enter
the soil, move along the tube and
form air gaps around the installed
access tube. Note: Do not attempt
an installation without the Access
Tube Installation Tripod. This item is
essential for a sound installation
using the preferred “through access
tube drilling” method.

Part C – Normalization Container

Part No. 70060

Normalization container

The normalization container is used
to obtain water counts for
EnviroSCAN, EnviroSMART, Diviner
2000 and EasyAG probes.

Slurry Access Tube Installation Kit (Part No. 07250)

Part No. 70400

Tool Bag No. 4

Bag specially designed to hold and
protect the slurry installation tools.

Part No. 70125

Part No. 70130

Auger Extension 0.5 m

Auger Extension 1.0 m

The auger extension rods can be
screwed into any auger, each other
and into the T-handle. Additional
auger extensions can be purchased
if required.

Part No. 70148

Regular Auger 61.0 mm
(slurry auger)

The regular auger 61.0 mm (slurry)
is used in slurry installations where
an oversized hole is pre-drilled.