Campbell Scientific Sentek EnviroSCAN Access Tube Installation Guide User Manual

Page 52

Toolkit items

Page 49

Standard Access Tube Installation Kit Complete (Part No. 07000)

Part A – Auger Kit (Part Number 07050)

Part No. 70100

1 x Tool Bag No 1

The tool bag is a specially designed
tool bag that holds and protects all
the tools that comprise the auger kit.

Part No. 70110

1 x Access Tube Cleaning,
Rag Tool

The access tube cleaning rag tool
holds a cotton cloth threaded
through the eyelet. The tool is
extended down the access tube.
This is used to wipe mud and water
from the inside wall of an access
tube.

Part No. 70112

1 x Access Tube Cleaning,
Brush Tool

The access tube cleaning brush tool
is a nylon brush tool used to remove
stubborn clay shavings from the
inside of the access tube wall.

Part No. 70120

1 x Auger Cleaning Tool
(small)

The auger cleaning tool is used to
quickly clean compacted soil from
the auger heads.

Part No. 70125

Part No. 70130

2 x Auger Extension 0.5 m

1 x Auger Extension 1.0 m

The auger extension rods can be
screwed into any auger, each other
and into the T-handle to provide
enough length to auger to a depth of
2.2 metres. Additional auger
extensions can be purchased if
required.

Part No. 70135

1 x Regular Auger 47.0 mm
diameter

The 47.0 mm regular auger is the
recommended auger and should be
used wherever possible. The
diameter measurement is marked on
the end of the auger. This auger is
used in the Standard Installation
Method. It drills through and ahead
of the access tube during the
installation process. This auger is
designed for light and medium
textured soils.

Part No. 70140

1 x Clay Auger 53.0 mm
diameter

The Clay auger 53.0 mm is only
used in moist, heavy clay soil where
augering with the 47.0 mm auger
becomes laborious and too difficult.