Campbell Scientific Sentek EnviroSCAN EasyAG SDI-12 Manual v 3.4 - Manual (Page 9)

EnviroSMART & EasyAG SDI-12 Probe Manual
Copyright © 1991 – 2003 Sentek Pty Ltd All rights reserved Page 4
SDI-12 Probe Interface
About setting up the EnviroSMART® and EasyAG® SDI-12 probe
interface
This section provides information on setting up the EnviroSMART and EasyAG SDI-12 probe
interfaces.
Why do I need to configure the SDI-12 probe interface?
The EnviroSMART and EasyAG SDI-12 probe interface must be configured to ensure valid
information is reported to the data logger when data is requested. This information includes the
number of sensors, normalization values (air and water counts) and calibration information.
By default, each SDI-12 probe interface is supplied with an SDI-12 address of “0”. If multiple probes
are to be installed on an SDI-12 bus, each SDI-12 probe interface must be assigned a unique address
(see section Addresses).
Warning!
Incorrect configuration information stored in the EnviroSMART or EasyAG SDI-12 probe interface will result in
incorrect volumetric water content (mm/10cm) readings being reported to the controlling device.
For more information on setting up the EnviroSMART and EasyAG SDI-12 probe interface, refer to
the Intelligent Probe Configuration Utility online help.