Campbell Scientific Sentek EnviroSCAN EasyAG SDI-12 Manual v 3.4 - Manual (Page 3)

EnviroSMART® and EasyAG® - Statements of Compliance
FCC note of compliance and statement of liability
Electro-Magnetic Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorientation or relocation of the receiving antenna.
• Connection of the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consultation with the dealer or an experienced radio/TV technician.
EMC approvals
The EnviroSMART and EasyAG SDI-12 probes comply with “EN61326:1997 EMC standard for
equipment for measurement, control and laboratory use”.
The equipment complies with the following specifications:
- EN55022/CISPR22
AS/NZS3548 Class B
FCC Part 15 Class B.
- IEC1000-4-2
- IEC1000-4-3
- IEC1000-4-4
- IEC1000-4-5
- IEC1000-4-6
Marking
The above EMC approvals allow the product to be marked CE, C-tick and FCC.
Modifications
Any modifications to any part of the equipment or to any peripherals may void the EMC compliance of
the equipment.
Radio Interference
The probe is not to be operated in free air as it may cause interference to radio communication devices