Campbell Scientific RF401-series and RF430-series Spread Spectrum Data Radios/Modems - Manual (Page 40)

RF401-series and RF430-series Spread Spectrum Radio/Modems
5.1.3 PakBus Tab
FIGURE 5-2. PakBus tab in DevConfig (with Default Settings)
The settings entered in DevConfig’s PakBus tab are only used when the radio
is set to the PakBus Node protocol. The PakBus Node protocol setting is for
standalone RF routers (repeaters). In this mode, the radio is not attached to any
datalogger or PC; it is ONLY a RF router. Each standalone router in a network
needs a unique PakBus address.
28