Campbell Scientific RF450 Spread Spectrum Radio - Manual (Page 30)

Appendix A. Installation Scenarios
FIGURE A.1-2. DevConfig Screen Showing Master Radio Settings for Example 1
TABLE A.1-1. RF450 Settings for Example 1
Master Slave(s)
Hardware RF450 connected to PC running LoggerNet RF450 connected to CR1000's CS I/O
port
Keep all factory default settings except:
Radio Operation Mode
Multi-Point Master Multi-Point Slave
Network ID 1726 (yours may be different) 1726 (yours may be different)
Frequency Key 1 (yours may be different) 1 (yours may be different)
Radio ID 4094 (to match LoggerNet's PakBus
Address) 2 (to match CR1000's PakBus Address)
(a)
(a) All Slave Radios in the network will have these same settings except for the Radio ID. The Radio ID should
match the PakBus Address of the datalogger it is connected to.
The Device Map in LoggerNet's Setup screen will look something like this:
A-2