Campbell Scientific RF450 Spread Spectrum Radio User Manual

Page 27

Text mode
Original mode

RF450 Spread Spectrum Radio

LEDs flash when LoggerNet command transmitted but no response from
datalogger:

1. Check SC12 cable on the datalogger's CS I/O port.

2. Check SDC address in RF450.

3. Check SDC address in datalogger.

4. Check the baud rate of all RF450s; they should be the same.

5. Check the baud rate of LoggerNet; it should match the baud rate of the

RF450s.

Using the diagnostics port.

A special FreeWave Diagnostics cable and software (CSI part number 20625)
can be useful in troubleshooting radio problems. Contact FreeWave Inc. for
more information on using the Diagnostics cable.