Campbell Scientific RF450 Spread Spectrum Radio - Manual (Page 29)

Appendix A. Installation Scenarios
A.1 Example 1: PC-to-RF Network
In this example, the Master radio is connected to a PC running LoggerNet (see
Figure A.1-1). Slave radios are connected to CR1000s in the field. LoggerNet
may be used to view real-time values from the dataloggers, collect data, set
datalogger clocks, and send programs.
Remember, each datalogger must have a unique PakBus Address.
Master
RF450
Slave
Slave
Slave PC Running
LoggerNet
/PC400
FIGURE A.1-1. Schematic of PC-to-RF450 Network
Using the Device Configuration Utility setup the Master and Slave RF450
radios according to Table A.1-1 below. The Deployment tab of DevConfig
should look similar to Figure A.1-2.
A-1