Campbell Scientific CS105/CS105MD Barometric Pressure Sensor - Manual (Page 14)

CS105/CS105MD Barometric Pressure Sensor
Example 5. CR10(X) Program for Measuring the CS105 Once Every Hour with Instruction 2
(Differential Measurement)
;{CR10X}
;
*Table 1 Program
01: 10
Execution Interval (seconds)
01: If time is (P92)
1: 59
Minutes (Seconds --) into a
2: 60 Interval (same units as above)
3: 41* Set Port 1* High
02: If time is (P92)
1: 0
Minutes (Seconds --) into a
2: 60 Interval (same units as above)
3: 30 Then Do
03: Volt (Diff) (P2)
1: 1
Reps
2: 25* ± 2500 mV 60 Hz Rejection Range
3: 4* DIFF Channel
4: 1* Loc [ P_mb ]
5: .184 Mult
6: 600 Offset
04: Do (P86)
1: 51*
Set Port 1* Low
05: End (P95)
06: If time is (P92)
1: 0
Minutes (Seconds --) into a
2: 60 Interval (same units as above)
3: 10 Set Output Flag High (Flag 0)
07: Real Time (P77)
1: 0110
Day,Hour/Minute
08: Sample (P70)
1: 1
Reps
2: 1* Loc [ P_mb ]
-Input Locations-
1 P_mb
*
Proper entries will vary with program and datalogger channel, and input location assignments.
** On the 21X use the 5000 mV slow range.
10