Campbell Scientific CM375 Portable 10-Meter Mast - Manual (Page 22)

CM375 Portable 10-Meter Mast
Step 6: Attach guy wires to anchors by first opening the turnbuckle to the
widest setting. Attach turnbuckle to wedge end of the guy cable, and then
attach the other end of the turnbuckle to an anchor (see FIGURE 3-25).
Open turnbuckle to widest setting.
Guy Cable Wedge Anchor
FIGURE 3-25. Turnbuckle fastened to guy cable and anchor
Step 7: If using rope ratchet to assist assembly, set to 7 feet and attach to
tension clamp on cable and to anchor end. Do this for both NE and NW
anchors and top and bottom guy cables (see FIGURE 3-26 and FIGURE 3-27).
Do not connect the SOUTH cables at this time. NOTE
FIGURE 3-26. Top and bottom guy cables fastened to an anchor
16