Samlex America TS-1500 - Manual (Page 15)

13
10 0
0
0
LOA D
10 0 10 0
1 00
10 0
0 0
0
LOA D LOA D
LO A D
LOA D
Table 6.1: Failure Mess ages On Fro nt Panel
10 0
100
100
100
0
0
0
0
LOAD
LOA D
LOA D
LOA D
(>187 5W)
Output
Overload
Output
Overload
(1500W~1750W)
Fail ure
Mes sage
Output
Overload
Ove r
Temperatu re
(1750W~1875W)
LED
Indicator LE D
In dicato r
AC Outpu t
Short Circuit
F ailure
M essa ge
Abnormal
AC Outpu t
Voltage
Abno rmal
Batte ry
Volta ge
6. 2 Ou tput Protection
(A)Bypass M ode: Uses "No Fu se Breaker" as aut omatic over current
(B)Inverter M ode: Under the "Invert er Mode", if any abnormal situ ation
(1)Over Temperature Pro tection: When t he i nternal t emperat ure is h igher
(2)AC Output Ab normal Pro tection: When t he AC output voltage of the
(3)AC Output Short Circuit Pro tection: W hen a short circuit situation
(4)Battery Voltage Ab normal Pro tection: Wh en the battery voltage is too
(5)Ou tput Ove rloa d P rotection: W hen out put is overloaded betwee n 15 00W
protect ion. When over current occurs, the button of the circuit breaker on
occurs, the front panel will send out fai lure messages t hrough the " Load
than th e limit value , the "O ver Temperature Protect ion" will be activated.
inverter is t oo high or too low, the unit will turn off and should be rest arte d
occurs at the output side of the inverte r or the load increase greatly in a
high or too low, this protection will be activated. T he inverter will auto-
~ 1750W, the inverter can continuously provide power for 3 minu tes. After
that, if the overload condition is not removed, the overload protection will
be activated. When the load is higher than 1875W, the overload protection
wil l act ivate instant ly. For these ove rload protections, once activ ated, yo u
should reset the unit.
recove r once the battery voltage go back to a safe level and users d o not
need to restart it.
short p eriod of time, the unit will turn off and should b e restart ed again.
again.
The unit will automatically turn off and should be restarted ag ain.
Meter" (Please refe r to Table 6.1).
the front panel will pop up and the inverter wil l shut down. At this time,
users should remove th e loads, rest art t he inverter and press down on the
button of t he circuit breaker and the AC output can now be provided
normal ly.