Samlex America TS-1500 - Manual (Page 14)

12
STEP 10: The LE Ds will change state by pressing the setting button for 1
STEP 11: Afte r ac tivat ing or canceling the "Saving Mo de", press the setting
seco nd a nd then release . Yo u can activate or ca ncel the "Sa ving
button for around 5 seconds a nd the i nverter will send out a "Beep"
sound. The button can be released an d al l the sett ings are finished .
The inverter will automat icall y sto re all the settings and t hen star t
t o operat e.
M ode" function by this adjustm ent .
5. 4 Remo te M onitoring So ftw are
6. 1 In put Protecti on
(A)Battery Polarity Protection: If the batt ery input is connect ed in reverse
(B)Battery Under Voltage Protecti on: When the battery vol tage is lower than
(C)Battery Over Volta ge Protection: When th e battery voltage is too high ,
(D)Sol ar C harger Over Cu rrent Protection: The m aximum chargin g current
Please choose suitable batteries that is within the rated i nput DC
voltage of TN/TS-1500 (refer to the S PEC). If the input DC voltage is
too low (ex. using 12Vdc battery bank for 24Vdc input models), TN/TS-
1500 can't be started up prop erly. If the i nput DC voltage is too high
(ex. using 48Vdc battery bank for 24Vdc inp ut models), TN /TS-1500
WARNING:
wil l be damaged!
polarity, the internal fuse will blow and the invert er shoul d be send back t o
the pre set value, the inverter will automatically terminate the output and
inverter will automatical ly terminate the output and t he built-in buzzer will
of the b uilt-in solar charger is 30A. I f the charging current is too high, the
internal fuse will blow and the inverter sh ould be send back to MEAN WELL
for repair.
activate to inform the us ers. Please refer to Table 6.1 for more detail about
the failure signals di splayed through the "Load Meter."
"Battery Low" si gnal on the f ront panel will light up. Please refer to Table 6.1
for more detail about the failure signals d isplayed through the "Load M eter."
MEAN WELL for repair.
(A)Users can also make Operating Mode, volt age/frequency, saving m ode,
(B)DB9-USB conversi on cable should not be use d because it wi ll not be
and transition voltage adjustments by using t his software. Software updat e
compa tible with the monitoring software.
can be downloaded from the MW we bsite. Please c ontact us or our
distributor if yo u ha ve any questions.
6. Protection