Samlex America TS-1500 - Manual (Page 12)

Energ y Saving
Mode
U PS Mode
Bat Low
Bat Low
Saving
Saving
On
On
● Lig ht
○ Dark
★ Fla shin g
●
★
★
★
★
○
Table 5.1 Operatin g Mode
Figure 5.1: Adjustment of Output Mode, Output Voltage,
Frequency, and Saving Mode
Use an i nsula ted stick to
press th is setti ng bu tton
ON
AC OUT PUT
SOLAR CH AR GE
AC C HA RGE
OF F BATTE R Y
100
0
10 0
0
S av ing
B at Low
On
S ettin g LOA D
INVERTE R
BY PASS AC I N
Remot e
port
10
5. 3 Proce dure of Setting Op erating Mode, O utput Voltage, Frequency, and
Sa ving Mode
Note: TS-1500 does not ha ve S tep 3~5.
STEP 1: The inverter should be t urned off while resetting. Input batteries
STEP 2: Use an insulat ed stick to press the setti ng button and then turn on the
STEP 3: P lease refer to Table 5.1 an d check the LED status to see if the
STEP 4: The LEDs w ill change state by pressing the setting button for 1
STEP 5: After selecting the Operat ing Mode, press the setting button for 3~5
STEP 6: Please refer to Table 5.2 and check whethe r the co mbination o f
shoul d be conne cted, A C main ca n e ither be connected or
power switch. After pressing for 5 seconds, the inve rter will send out
Operating Mode is the one you need. If yes, please skip to STEP 5.
second and t hen rele ase. Operating Mo de can be adjusted as
seconds and the i nverter will send out a "Beep" sound. Th e button
output vol tage and frequen cy i s the one you need. If yes, please skip
to STE P 8. If change i s req uired, please follow STEP 7~11.
can be released and you can g o on to the setting section of
"Voltage/f requency."
required.
If change is required, pleas e follow STE P 4~11.
a "Beep" sound. Users can release the button and go into the setting
pr ocedure.
di scon nected, and the loads should be removed .