LBL Lighting Tubes 7 SP - Manual (Page 4)

4
Insert the fixture rods into the Fusion Jack assembly rod, make
sure the fixture rods are aligned with the top of the Fusion
Jack assembly rod.Tighten the two M3 set screw with 1.5 MM
Allen wrench.
M3 SET SCREW
1.5 MM ALLEN
WRENCH
FIXTURE ROD
FUSION
JACK
ASSEMBLY
ROD
(H2)
GLASS SHADE
FIXTURE
FUSION
JACK
The height (H2) is measured from bottom of the bottom glass
shade to the middle of the top socket assembly rods.
Determine the desired (H2) fixture height.The height (H2) is
39" inches when the fixture rods are not cut.
TOP SOCKET
ASSEMBLY ROD
Insert the fixture rods into the top Fusion Jack assembly rods,
and tighten the two M3 set screw with 1.5 MM Allen wrench.
M3 SET SCREW
1.5 MM ALLEN
WRENCH
FIXTURE ROD
FUSION JACK
ASSEMBLY ROD
M3 SET
SCREW
1.5 MM
ALLEN
WRENCH
SOCKET PIN HOLE
Loosen the four M3 set screws on the (Do Not Remove)
middle socket assembly rods.
Insert the Fusion Jack assembly rods from the end opposing
the socket pin holes onto the fixture rods. Make sure that the
bottom Fusion Jack assembly rods are in line with the top
Fusion Jack assembly rods and tighten the two M3 set screws
with the 1.5 MM Allen wrench.
Repeat steps 1 through 9 to assemble the other fixture arms.
MIDDLE FUSION
JACK ASSEMBLY
ROD
FIXTURE ROD
TOP FUSION JACK
ASSEMBLY ROD
2E
5
2G
2F 2J
6
9
7
2I
8
10
9
5
5
7
8
8 8
8
6
9