Siemens 30inc iSlide Single Oven - Manual (Page 5)

English 3
Preparation
Before you Begin
Tools and Parts Needed • Phillips head screwdriver
• Measuring tape
• Drill with bit (1/8")
Parts Included • Phillips head screws (6)
30” Appliances
Dimensions for 30” Wall-Mounted Units
28 1/2"
(724mm)
28 1/4"
(718mm)
27 "
(686mm)
27 13/16"
(706mm)
min. 4 3/4" (121mm)
max. 31 3/8" (797mm)
24 "
(610mm)
23 7/8" (606mm)
22 " (559mm)
29 1/16"
(738mm)
29 3/4"
(755mm)
Single Oven 30”
It is good practice, when oven is
installed at the end of a cabinet run,
adjacent to a perpendicular wall or
cabinet door, to allow at least 1/4”
space between the side of the oven
and the wall/door.
For oven support, install 2x4’s
extending front to back flush with the
bottom and the side of the opening.
The supporting base must be well
secured to the floor/cabinet and level.
Note: The conduit box must be
installed either above or below the
unit. If the conduit box is installed
below the unit, a 2” diameter hole or
space is required between the back
wall and the right rear of the 2x4
supports.
The cabinet base must be flat and
capable of supporting a weight of at
least 190 lbs (86 kg).